J. Thrinadh, S. Datta, and M. Masanta,"Studies on chip morphology and modes of tool wear during machining of Ti-6Al-4V using uncoated carbide tool: application of multi-walled carbon nanotubes added rice bran oil as nanocutting fluid", Machining Science and Technology, an International Journal, Taylor and Francis 2020, 10.1080/10910344.2020.1815040       Article

J. Thrinadh and S. Datta,"Machinability of Ti-5Al-2.5Sn for electro-discharge machining: an experimental investigation", Sadhana, Springer 2020, 10.1007/s12046-020-01479-y       Article

S. P. Sahoo and S. Datta,"Dry Machining Performance of AA7075-T6 Alloy Using Uncoated Carbide and MT-CVD TiCN-Al2O3-Coated Carbide Inserts", Arabian Journal for Science and Engineering, Springer 2020, 10.1007/s13369-020-04947-z       Article

J. Thrinadh, S. Datta, and M. Masanta,"Study of surface integrity and machining performance during main/rough cut and trim/finish cut mode of WEDM on Ti–6Al–4V: effects of wire material", Journal of the Brazilian Society of Mechanical Sciences and Engineering, vol.41, pp.151, Springer, February 2019, 10.1007/s40430-019-1656-4       Article

M. Kumar, S. Datta, and R. Kumar,"Electro-discharge machining performance of Ti–6Al–4V alloy: studies on parametric effect and phenomenon of electrode wear", Arabian Journal for Science and Engineering, vol.44, no.2, pp.1553–1568, Springer, February 2019, 10.1007/s13369-018-3632-1       Article

. Rahul, S. Datta, B. B. Biswal, and S. S. Mahapatra,"Machinability analysis of Inconel 601, 625, 718 and 825 during electro-discharge machining: On evaluation of optimal parameters setting", Measurement, vol.137, pp.382-400, Elsevier, April 2019, 10.1016/j.measurement.2019.01.065       Article

M. Rakesh and S. Datta,"Effects of cutting speed on chip characteristics and tool wear mechanisms during dry machining of inconel 718 using uncoated WC tool", Arabian Journal for Science and Engineering, vol.44, pp.7423–7440, Springer 2019, 10.1007/s13369-019-03785-y       Article

. Rahul, S. Datta, and B. B. Biswal,"Experimental studies on electro-discharge machining of Inconel 825 super alloy using cryogenically treated tool/workpiece", Measurement, vol.145, pp.611-630, Elsevier, October 2019, 10.1016/j.measurement.2019.06.006       Article

J. Thrinadh, S. K. Sahu, S. Datta, and M. Masanta,"EDM performance of Inconel 718 superalloy: application of multi-walled carbon nanotube (MWCNT) added dielectric media", Journal of the Brazilian Society of Mechanical Sciences and Engineering, vol.41, no.305, Springer, August 2019, 10.1007/s40430-019-1813-9       Article

. Rahul and S. Datta,"Electrical discharge machining performance of deep cryogenically treated inconel 825 superalloy: emphasis on surface integrit", Metallography, Microstructure and Analysis, vol.8, no.2, pp.212-225, Springer, April 2019, 10.1007/s13632-019-00519-2       Article